Welcome To The

BEST OF THE WEST

HOSPITAL

Greetings Fellow Marx Fans & Circle X Ranch Hands!

After a lifetime, of being told that no adhesive would repair Marx Johnny West figures, it is my pleasure to finally announce the discovery/invention of EasyFix. EasyFix is a new adhesive to repair Johnny West figures. And, the EasyFix Product Line is the first coordinated line of products created with the Care and Repair of Johnny West figures in mind.

EasyFix industrial adhesive is a high quality product of modern German chemistry. EasyFix represents a sensational development in the field of adhesive technology. As a result, EasyFix has a limitless range of possibilities. EasyFix meets the highest demands in terms of elasticity, resistance to cold and heat, and to chemicals and water. It's outstanding characteristics are: simple preparation with no mixing necessary, quick setting even on absorbent surfaces, and almost unbelievable adhesion.

Best of all, it works on Johnny West figures!

How To Disassemble and Reassemble a Marx Figure
With The Aid of the Marxman Bros. Creations
Spring Extractor (c).

The images below show a plastic Marx Indian Shield that has had 2 of the feathers repaired the using EasyFix products. Click image to enlarge.

Click on the photos to make them bigger

Plasti-Marx Mike Hazard Mike as he arrived from his hard trip from Mexico.	EasyPrep 1 Bottle Makes 2 Gal Mix EasyPrep in a sealable container for reuse. Excellent for prepairing sufaces so paint adheres better, too!	Rinse in Cool Water EasyPrep rinses right off.	EasyPrep can be reused! Just pour EasyPrep back into a sealable container and use over and over until dirty. It's inexpensive and lasts a long time!
BOTW Hospital Spring Extractor The BOTW Hospital Spring Extractor makes disassembling a Marx figure easy. Free with any purchase or make your own.	A Hair Dryer Speeds Drying The dryer was used for 10 minutes on low to heat to reduce the time necessary to make the repair	EasyPrime is the activator. Two Coats Of EasyPrime allowing a few minutes for it to evaporate between coats prepares the surface to be adhesed.	EasyFix Adhesive After a couple of minutes the surface is ready. Spread a small coat of EasyFix on one side of the repair surface and press the two pieces firmly together for 1 minute.
The Repair After I Minute EasyFix cures completely within 7 hours but is ready to sand or paint in only a few minutes.	A Butter Knife Works Great! Using the Spring Extractor just lift one loop of the spring above the socket. Then, slide the blade of the butter knife in between resting the flat surface on the socket.	The total repair was done in one hour. Mike was allowed only 15 minutes of cure time for this picture.

We're Proud To Announce That EasyFix Products Can Also Be Purchased At



~~~ Click Image To Go To The Vintage Toy Room ~~~